#Miroir projector hack activation' how to
#Miroir projector hack activation' activation code

Some devices may not have this ability, but they can still be used with the projector to project videos, photo slide shows, and some app content (this functionality is app dependent). NOTE: After syncing with the projector you may see your device’s screen being mirrored by the projector.

Allow the projector 15 to 20 seconds to fully start up and sync with your device.

#Miroir projector hack activation' activation code

If this is the first time you are using the projector, and the date code stickered on the underside of the device is smaller than 18285, you will need to activate the projector with the activation code from your sales receipt.

Power on the projector by flipping the power switch to the on position.

If no external speaker is connected, the projector's internal speaker will be used for audio.

If desired, connect a speaker to the 3.5mm audio out jack.

#Miroir projector hack activation' how to

The following help articles will help you determine how to connect a variety of popular phones, laptops, tablets, streaming devices and other devices to your Miroir projector:.

NOTE: Some devices may require an adapter to connect to your device.

Connect the included HDMI cable to the HDMI port on the projector and the other end to your device.

IMPORTANT: Fully charge the battery before the first use (approximately 3-4 hours).

To power the projector with the built-in battery, simply turn the projector on.

Once connected, the power indicator light will illuminate red on the projector to show it is connected to power.

To power the projector with the Micro USB to USB cable, connect the Micro USB to the projector’s and plug the other end into a USB port.

The projector can be powered using the included Micro USB to USB cable or the built-in battery.

The blue system indicator light will come on if the battery power is getting low. The built-in battery is charged using the included Micro USB to USB cable. Operating the Projector Charging the Battery This button is a small recessed button, so you will need something small, such as a paper clip, to press the button.

Reset button - Press to reset the projector.

The USB cable can be plugged into a USB wall outlet or a USB port on a computer for power.

Micro USB power port - Connect the supplied Micro USB to USB charging cable to charge the projector's internal battery or provide the projector with power.

HDMI input - Connect the HDMI cable to this port and a device that supports HDMI video output to project content.

3.5mm Audio out port - (Optional) Can be used to connect an external speaker or headphones.

Power indicator light - This light will illuminate red when the projector is connected to power to show that the battery is charging or receiving power.

System indicator light - This light will illuminate briefly as the device starts up, and will also come on if the projector's battery power is getting low.

Power switch - Slide power switch forward (toward the projection lens) to power the projector on.

Volume down control - Decrease the volume output of the projector.

Volume Up control - Increase the volume output of the projector.

Focus wheel - Roll left or right to fine tune the image focus.